How to apply vinyl decals & iron on transfers
Checkout our videos & instructions below
Applying vinyl decals
From small to large decals, we will run you through the steps!
Vinyl Decal Instruction walkthrough
Step 1. Clean the Surface
Wipe the area where you’re applying the decal to remove dust, oil, or moisture.
Let the surface dry completely.
Step 2. Peel & Position
Slowly peel the backing paper away from the decal at an angle.
Hold the decal by the transfer tape, position it on your surface, and lightly press it into place.
Step 3. Smooth It Down
Using a card (or your finger), firmly rub over the entire decal to push out any air bubbles and help the vinyl stick properly.
Step 4. Remove the Transfer Tape
Carefully peel the transfer tape away at a slow angle.
If any part of the decal lifts, lay the tape back down and repeat Step 3.
Applying iron on transfers
From start to finish, if it's your first time or need a refresher, we got you!
How to Apply Your Iron-On Transfer
Step 1. Position Your Design
Place the transfer onto your garment with the shiny, clear carrier sheet facing UP.
Make sure the design is straight and lying flat.
Step 2. Set Your Heat
• Home iron: Set between Cotton & Linen
Steam must be turned OFF
• Heat press: Set to 150–160°C
Step 3. Press
Place the supplied parchment paper over the transfer.
Press firmly for 15 seconds without moving the iron.
Step 4. Peel
After 20-30 seconds, the clear sheet will be cool to touch. Once cooled. Slowly peel away clear carrier sheet.
If any part of the design does not lift, lay the parchment paper back on and press again for 5 seconds, then peel.
Tag us on Instagram @ntlprint
Photo reviews help other customers see our products in real life and allow us to keep improving on what we make.